Test bench slide rail: generally adopts three-section silent slide rail, treated with high temperature spraying anti-acid and alkali paint, can resist acid and alkali, corrosion resistance, push lightly and smoothly without noise, high strength, can be used normally for more than 50,000 times, and will not deform under long-term load.
The countertop should keep its integrity as much as possible, and should also minimize the joints, and can not be connected in a longitudinal manner. Check whether there is a water stop ditch under the outer edge of the countertop, check the position and connection of the water, electricity, gas and air pipes, check whether there is deviation from the design, communicate in time, and clarify the solution. The use of laboratory furniture is often in contact with water, electricity, gas, chemical substances and materials, and instruments and equipment, so it is outside the pursuit of experimental environment and flexibility in installation and layout.
The upper part of the fume hood is equipped with ventilation holes, so it is better to close the glass window to enter the atmosphere to avoid negative pressure. The fume hood shell is made of metal material, which is not fireproof. The inner cavity is made of anti-fold special plates, stainless steel plates and other materials with or without seals, and the table tops are made of solid physical and chemical plates or stainless steel plates that are resistant to acid, alkali, heat and seal.
The cabinet material of the all-steel test bench is made of cold-rolled steel plate sprayed with 80um thick epoxy resin powder, which is resistant to acid and alkali corrosion. Upper seat inner lining board: It is made of 6mm anti-double special board, and the assembly screws are covered with plastic cover plate to avoid contact with the gas in the cabinet and keep it beautiful.